Path dan guide curve sketch for sweep
We can make a 3d-featured sweep, using a sketch and sketch 2 alone, or with the addition of a guide curve.
To create a sweep using the path and guide curve, the steps we have to do is, Once we open the new document, create a path and the first guide curve; then make a section.
Guide curve must coincide with the profile or to a point in the sketch to make a sweep.
intermediate profiles for the sweep depends on both the path and guide curves.
The path must be a single entity ie lines, arcs, and so on
Horizontal or vertical relations can be added automatically when we we do section sketch.
These relations affect the form of intermediate sections.
Path and guidecurve may differ in length.
If the curve is longer than the guide path, as long as the path sweeps.
If the curve is shorter than the guide path, sweep the same length as the shortest guide curves.
