Drawing using 3D Sketch
The first step we have to do is create a 3D sketch of the frame outside.
Click New and create a new part.
Click on the toolbar Sketch 3D Sketch.
Click the Line button on the toolbar Sketches and sketches about 100mm long lines on the XY plane from the origin.
The pointer changes to while sketching horizontally on the XY plane.
Sketch the line for the length estimation, the dimension of the right length later.
Click the Select button on the Standard toolbar, and select the end point of beginning of the line.
In PropertyManager, make sure that the endpoint is exactly at the origin (0, 0, 0 as shown below parameter), is the same origin (as shown in relationship that exists) and Full Set (as shown in the information).
If the endpoint is not at the origin:
Under Parameters, set the coordinates X, Y coordinate, and Z coordinates to 0.
Click Add Relationship Repair.
Now the point is Fully Defined, as shown in the information.
Reducing the size of the sketch to give a broad sketch opens on the right side of the chart area.
Click the Line (Sketch toolbar) and continued to sketch the lines from the end point of the 100mm line. Every time you start a new line, the origin for the coordinate system is currently showing at the beginning of a new line to help direct you.
Sketch the following lines to the approximate length, then the long dimension of the right later.
